the Q pinche claw…

I have been getting a lot of requests from fly tiers around the world asking about my DIY Silicone Pinche Claws. I developed these Pinche claws in conjunction with the great Bauer Crab design which ended up becoming my Qs Pinche Crab. It has been a popular pattern in Belize for permit. The great, Will Bauer showed me how to tie his amazing pattern at the San Mateo Outdoor show back in the nineties, it was and still is a stable, deadly fly pattern used in Belize where Will pioneered the permit fishery back in the late eighties. The reason to the addition and development of the Pinche Claw is that silicone is buoyant and will float. These Pinche claws will take on a defensive posture when the crab, shrimp, crayfish or baby lobster lands on the bottom. They also will land in the right orientation when they fall. Very important when stalking permit. I think it makes a positive addition to any crab pattern and really works well. Always swim and test your flies before fishing them, remember everyone is a snowflake.

I hope this all makes sense, I threw it together rather quickly so if there are any questions, please fire away. I try to keep it as simple as possible so we can push the crab evolution forward…LOL

Start with some wax paper on a board, You will need scissors, CLEAR silicone, EP fibers, bodkiin, water proof marking pens, a ruler and lighter.

measure a length of EP fibers about 1/4 inch in width, leave enough length so you can make a knot, burn and edge so you can put through loop easier, then knot piece together

Color with sharpie, use your bodkin to add and smooth clear silicone through fibers, on both sides, pull in loose fibers with tip of bodkin then set to dry.

You can make DIY eyes by burning mono, then marking them with sharpies and adding Tuffleye or epoxy to build up eyes to size. Any clear silicone will work. The sketch will show you how I cut the claw sahpes once they dry, if you want your arms to curve then hold them in that position and add some five minute epoxy, tuffleye, or zap quick set glue to hold shape. Good luck and have fun…

-Al Q